Scalar i6000 Installation Guide Super Doc
35
Checking the Display Cable Connector
Make sure the display cable connector (W22 to touch screen) did not get dislodged from the LMM backplane
during the cable replacement/install procedures above. The display cable connector is J16 and is shown in
Figure 17
.
Figure 17
Display Cable Connector on LMM Backplane - J16
Routing and Connecting Module Cables
Required tools: Phillips screwdriver
1
On the back of the existing control module or last expansion module, do the following:
Note
The cables will be preinstalled on the LBX board in the expansion modules.
You must route them through the hole in the bulkhead to either the control
module or previous expansion module.
connector: J16
plug: W22
to touch screen
