Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Installing the DX-Series System
33
Figure 29 Removing the
AC Power Connector
Screws
2
Install the cable clamp on the power sequencer using two pan head
PHILLIPS screws provided in the accessory kit (see
figure 30
).
Figure 30 Installing the
Cable Clamp and Power
Cable
3
Install the AC power cable through the cable clamp and into the AC
power sequencer. Tighten the cable clamp with the tension screw to
secure the power cable (see
figure 31
).
Note:
A rubber shim is included with the cable clamp for power
cables smaller than the cable clamp.
AC power connector
Screws
Cable clamp
Screws