Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
28
Installing the DX-Series System
3
Determine the depth of the rack (30 in, 76.2 cm minimum) and assemble
each DX-Series controller rail with two PHILLIPS screws and locking
plate at the appropriate depth (see
figure 23
).
Figure 23 Assembling the
Controller Rails
4
Install the DX-Series controller rails into the rack with four 10-32 x .50 in.
PHILLIPS screws on each side (two in the front and two in the back) (see
figure 24
).
Note:
To support bracket installation in racks with through holes
(see
table 2
), mounting plates are provided with the switch
accessory kit for use behind the rail mounting positions.
Locking plate
Locking plate
Screws