![background image](http://html1.mh-extra.com/html/quantum/dx100/dx100_unpacking-and-installation-instructions_3534091058.webp)
Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
58
Configuring the DX-Series System
Connecting to the DX-Series Controller
0
To initially configure the DX-Series system:
1
Connect a 9-pin RS-232 null modem cable to the COM port in the left-
most PCI slot the back of the DX-Series controller and to a COM port on
the service PC (see
figure 51
).
Figure 51 Connecting the
Service PC to the
DX-Series Controller
2
Open a HyperTerminal window on the service PC and set the following
properties:
• Baud rate
115200
• Data bits
8
• Parity
none
• Stop bits
1
• Flow control
none
• Emulation
ANSI
Configure Service Options
0
To configure the service options:
1
Press
<Enter>
to access the command prompt.
2
At the command prompt, type
service
and press
<Enter>
.
The system prompts you for a password.
3
Type the <service password> and press
<Enter>
.
The system displays the DX-Series Service Menu (see
figure 52
).
Serial port
DX30 shown