Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Installing Additional Storage Arrays
41
Installing Additional Storage Arrays
0
To install additional storage arrays:
1
Refer to
Installing the DX-Series Storage Array
on page 15.
Cabling the DX-Series System
0
There are several possible cabling scenarios for the DX-Series system
depending on the installation. Refer to the following sections for cabling
examples:
•
Installing the SFP Connectors
•
Verifying Storage Array Dip Switches
•
Cabling a DX30
•
Cabling a DX100
•
Power Cabling
Installing the SFP
Connectors
0
Both the Fibre Channel switch and the storage array(s) need SFP (Small Form-
Factor Pluggable) connectors installed prior to connecting Fibre Channel
cables. The SFP connectors are located in both the Fibre Channel switch and
storage array accessory kits.
Install the following SFP connectors:
1
Fibre Channel switch ports (see
figure 40
) that have Fibre Channel cable
connections (DX100 requires four SFPs plus two for every installed
storage array).
Note:
If this is an upgrade to an existing DX-Series system, the additional
storage arrays must be installed below the original DX-Series
system.
Tech Tip:
If more than two storage arrays are to be installed, start
the installation with the bottom storage array and work
up.
Caution:
Use extreme care when handling the LC-to-LC Fibre Channel
cables. Do not pinch the cables and keep the connector ends
free from debris.
