Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Preparing for the Installation
7
Preparing for the Installation
0
Before you begin the installation procedure in this section, make the
following preparations as described in this section:
•
Providing Necessary Tools and Equipment
•
Taking ESD Precautions
Providing Necessary
Tools and Equipment
0
Provide the following tools for unpacking the DX-Series system:
• #1 PHILLIPS® screwdriver
• #2 PHILLIPS screwdriver
• #1 Flat head screwdriver
• Antistatic wrist strap included in accessory kit
Taking ESD
Precautions
0
Some components within the DX-Series system contain static-sensitive parts.
To avoid damaging these parts while performing installation procedures,
always observe the following precautions:
• Keep the DX-Series system turned off during all installation procedures.
• Use an antistatic wrist strap (included in the accessory kit).
• Keep static-sensitive parts in their original shipping containers until
ready for installation.
• Do not place static-sensitive parts on a metal surface. Place them inside
their protective shipping bag or on an antistatic mat.
• Avoid touching connectors and other components.
Unpacking the DX-Series System
0
This section explains how to unpack the DX-Series system components and
move them to their final installation location. The DX-Series system is
shipped in two configurations: DX30 and DX100 (see
table 1
):
Note:
Dry climates and cold-weather heating environments have lower
relative humidity and are more likely to produce static electricity.