NetApp FAS22 Series, Manual

Page: 1 / 9

Replacing the chassis on a FAS22xx system
To replace the chassis, you must remove the power supplies, hard drives, and controller module or modules from the old
chassis, remove the old chassis from the equipment rack or system cabinet, install the new chassis, and then reinstall the
components into the new chassis.
Before you begin
All other components in the system must be functioning properly; if not, you must contact technical support.
About this task
• You can use this procedure with all versions of Data ONTAP supported by your system.
In this procedure, a
Cluster-Mode system refers to a system running Data ONTAP 8.x in Cluster-Mode. A 7-Mode system
refers to a system running Data ONTAP 8.x in 7-Mode.
• This procedure refers to HA pairs, which in releases prior to Data ONTAP 8.0 were called active/active configurations.
• This procedure assumes you are moving all disk drives to the new chassis.
• This procedure is written with the assumption that the chassis is nonfunctional and, therefore, the controller modules in it are
not serving data.
• This procedure is written with the assumption that you are moving the controller module or modules to the new chassis, and
that the chassis is a new component from NetApp.
Steps
1.
Removing the power supplies
on page 1
2. Removing the controller module on page 2
3. Moving disk drives to the new chassis on page 3
4.
Removing the chassis from the equipment rack or system cabinet
on page 5
5.
Installing the new chassis into the equipment rack or system cabinet
on page 5
6. Installing the power supplies on page 5
7. Reinstalling the controller modules and booting the system on page 6
8.
Verifying and setting the HA state of the chassis
on page 6
9.
Running diagnostics on the chassis
on page 7
10. Completing the replacement process on page 9
Removing the power supplies
To remove the power supplies from the chassis, you must perform a specific sequence of steps.
Steps
1. If you are not already grounded, properly ground yourself.
2. If you have not already done so, turn off the power to the target power supply and remove the power cord.
3. Squeeze the latch on the cam handle until it releases, then open the cam handle fully to release the power supply from the
midplane.
1 215-06298_A0 Copyright
©
2012 NetApp, Inc. All rights reserved.