QMS Magicolor 330, Operations

Page: 155 / 226

!
' !) ) .
%
This service message... Means...
CALL FOR SERVICE AUTO DENSITY
An error has been detected
with the item indicated in the
service message. Correction
of these errors is performed
by qualified QMS-authorized
service provider only. Contact
the vendor from who you
purchased the printer. If you
cannot get service from your
vendor, see appendix A,
“QMS Customer Support,” for
more information.
» Note: A service message
sometimes occurs as a
result of an unusual combi-
nation of events, not
because of an actual prob-
lem. When the printer stops
and a service message dis-
plays in the message win-
dow, turn the printer off and
then back on. This often
clears the service message
indicator, and printer opera-
tion resumes. Always try this
before making a service call.
CALL FOR SERVICE BTR2 ERROR
CALL FOR SERVICE ENGINE MEMORY
CALL FOR SERVICE ENGINE NVR
CALL FOR SERVICE ENVIRO SENSOR
CALL FOR SERVICE FUSER LAMP
CALL FOR SERVICE FUSER TEMP HIGH
CALL FOR SERVICE FUSER TEMP LOW
CALL FOR SERVICE FUSER WARM UP
CALL FOR SERVICE HIGH DENSITY
CALL FOR SERVICE LOW DENSITY
CALL FOR SERVICE MAIN MOTOR
CALL FOR SERVICE PAPER MOTOR
CALL FOR SERVICE PCDC ERROR
CALL FOR SERVICE ROS MOTOR
CALL FOR SERVICE ROTARY SENSOR
EXCESSIVE TONER COVERAGE
MCU SYNC ERROR
REPLACE BELT CLEANER
REPLACE BTR2
[bias transfer rollers]
REPLACE FUSER
TRC ERROR
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500