QMS Magicolor 330, Operations, Page: 169 / 226

)-.
) .
'& !) ) .
Print a status page from the control panel. If you are
using the serial interface, is the baud rate (speed of data
transmission) of the printer, the computer, and your soft-
ware application the same? See chapter 4, “Printer Con-
figuration,” in the
Reference manual.
If you still cannot identify the problem, contact
your vendor.
5 Is the printer printing codes or not printing at all when in
ESP mode?
Reconfigure the port to the specific printer emulation of
the file you are trying to print. See chapter 4, “Printer
Configuration,” in the
Reference manual for instructions.
If a PostScript file prints PostScript statements while the
printer is in ESP mode, increase the ESP timeout. See
chapter 4, “Printer Configuration,” in the
Reference man-
ual for instructions.
If you continue to have problems with the ESP mode
selecting the appropriate printer emulation, contact
your vendor.
6&"&
The OPC drum is extremely sensitive to bright light and direct sun-
light. Always leave it in its protective bag until you are ready to install
it. Any exposure to light should be limited to two minutes. If you sus-
pect the belt is damaged due to exposure to light, put the drum in a
dark place to recover. Depending on the amount of exposure, recov-
ery may take up to two hours. Recovery time is dependent on the
amount of exposure sustained, and recovery is not guaranteed.
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500