QMS Magicolor 330, Operations

Page: 19 / 226

!
$ " ##
4 Align the four corners of the
media stack, and insert it
under the fluke at the front-
right side, with the printing
side facing down.
The media stack will cover the
arrow embossed on the lower-
right corner of the media tray.
Do not load more sheets than the maximum specified.
» Note: Make sure the top sheet is under the fluke.
Load letterhead and memo paper printing-side down with the top
of the media (the letterhead or memo information) toward the
back of the cassette.
5 Set both media guide clips.
» Note: If a media guide clip
is pressed too tightly against
the media, it may cause a
media jam.
Check that the left media
guide clip is inserted into the
proper hole in the scale.
» Note: Be sure the paper
corners are not bent upwards
by the guides.
» Note:
Automatic media-size detection cannot be assured if the
left guide clip is even slightly out of position. If this occurs, slide
the media guide clip momentarily to the left edge, then reposition
it according to the scale.
119dv.eps
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500