QMS Magicolor 2 Desklaser, Install Manual

Page: 33 / 60

5 Slide the media cassette back into the printer.
6 If you have a lower input feeder, repeat steps 1 through 5 to load that media
cassette.
Caution:
Although the QMS
magicolor
2 DeskLaser was designed for occasional
printing on a wide range of media types, it is not intended to print exclusively on a
single media type except plain paper. Continuous printing on media other than
plain paper (such as envelopes, glossy stock, labels, thick stock, transfer media, or
transparencies) may adversely affect print quality or reduce engine life.
After 200 1-sided pages (or 100 2-sided pages) of a continuous print run of plain
paper, the
magicolor
2 DeskLaser automatically pauses for 3 minutes to cool
down the engine. This occurs for monochrome or color printing. After this initial
cooldown pause, the printer automatically resumes its printing. From that point
forward while doing continuous printing, the 3-minute cooldown pause occurs every
50 pages until the continuous printing stops. After an extended idle period, this
50-page interval automatically resets to 200 pages. This process is provided to
maintain the rated duty cycle of the printer and to ensure reliable printer opera-
tion with optimum output quality.
4 Load the paper.
A fill limit mark is provided on the
inside left side of the cassette. The
media cassette holds 250 sheets of
20 lb bond (75g/m
2
) paper. (Paper
is packed in reams of 500 sheets.)
Caution: Do not overfill the
cassette.
» Note: The face-down output tray
has a 250-sheet capacity. Jamming
may occur if you allow media to
accumulate more than 250 sheets
at a time.
The paper should face up with its top toward the rear of the cassette. An arrow
on the paper package label indicates the face-up side of the paper.