QMS 2060, Operation

Page: 60 / 158

Introduction
QMS 2060 Print System Operation 4-2
Introduction
This chapter describes how to handle and clean the printer.
Blurred or splotchy prints and media jams can result from dusty
printer parts. Regular cleaning takes only a few minutes and helps
ensure print quality. Printer parts that require cleaning are the paper
pick-up rollers and the outside surface of the printer.
Handling the Printer
Handle the printer with care to preserve its life. Abuse may cause
damage. Keep the following guidelines in mind:
n
Do not place anything on the top of the printer.
n
Do not place anything on the multipurpose tray except the media
being used for printing.
n
Avoid spraying cleaning solution directly on the printer’s surface;
the spray could penetrate through the air vents of the printer and
damage the internal circuits.
n
Be careful when cleaning the inside or removing paper jams, as
the fixing assembly and other internal parts become very hot.
Leave the printer cover open before handling the inside of the
printer.
n
Do not close the covers abruptly, or expose the printer to vibra-
tions.
n
Do not cover the printer immediately after using it. Turn it off and
wait until it cools down.
n
Do not leave the printer open for any length of time, especially in
well-lit places; light may damage the toner cartridge.
n
Do not open the printer during printing and do not tap paper
stacks on the printer.
n
Do not tilt, lubricate, or disassemble the printer.