Qlogic SANbox 5800V Series, Interface Manual

Page: 309 / 422

14 – Command Reference
Command Listing
59263-02 A 14-129
A
The following is an example of the Set Setup System Logging command:
SANbox (admin) #> set setup system logging
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
LocalLogEnabled True
RemoteLogEnabled False
RemoteLogHostAddress 10.0.0.254
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
LocalLogEnabled (True / False) :
RemoteLogEnabled (True / False) :
RemoteLogHostAddress (hostname, IPv4, or IPv6 Address) :
Do you want to save and activate this system setup? (y/n): [n]
The following is an example of the Set Setup System Ntp command:
SANbox (admin) #> set setup system ntp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
NTPClientEnabled False
NTPServerDiscovery Static
NTPServerAddress 10.20.10.10
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
NTPClientEnabled (True / False) :
NTPServerDiscovery (1=Static, 2=Dhcp, 3=Dhcpv6) :
NTPServerAddress (hostname, IPv4, or IPv6 Address) :
Do you want to save and activate this system setup? (y/n): [n]