Qlogic SANbox 5800V Series, Interface Manual

Page: 266 / 422

14 – Command Reference
Command Listing
14-86 59263-02 A
S
Set Config Port
Sets the port configuration parameters for one or more ports. The changes you
make with this command are not retained when you reset or power cycle the
switch unless you save them using the Config Save command.
Authority
Admin session and a Config Edit session
Syntax
set config port [port_number]
or
set config ports [port_number]
Keywords
port [port_number]
Initiates an edit session in which to change configuration parameters for the port
number given by [port_number]. If you omit [port_number], the system begins with
port 0 and proceeds in order through the last port. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
Enter “q” to end the configuration for one port, or “qq” to end the configuration for
all ports.
Table 14-19 describes the port configuration parameters.
ports [port_number]
Initiates an editing session in which to change configuration parameters for all
ports based on the configuration for the port given by [port_number]. If you omit
[port_number], port 0 is used. For each parameter, enter a new value or press the
Enter key to accept the current value shown in brackets. Enter “q” to end the
configuration.
Table 14-19 describes the port configuration parameters.
Table 14-19. Port Configuration Parameters
Parameter Description
AdminState Port administrative state:
„
Online – Activates and prepares the port to send data.
This is the default.
„
Offline – Prevents the port from receiving signal and
accepting a device login.
„
Diagnostics – Prepares the port for testing and prevents
the port from accepting a device login.
„
Down – Disables the port by removing power from the port
lasers.