Qlogic SANbox 5800V Series, Interface Manual

Page: 233 / 422

14 – Command Reference
Command Listing
59263-02 A 14-53
A
Ipsec Policy
Manages policies in the Security Policy database.
Authority
Admin session and an Ipsec Edit session
Syntax
ipsec policy
copy [policy_source] [policy_destination]
create [policy]
delete [policy]
edit [policy]
list
[option]
rename [policy_old] [policy_new]
Keywords
copy [policy_source] [policy_destination]
Creates a new policy named [policy_destination] and copies the configuration into
it from the policy given by [policy_source]. You must enter the Ipsec Save
command afterwards to save your changes. [policy_destination] must not begin
with
DynamicSP_ , which is reserved for dynamic policies.
create [policy]
Creates a policy with the name given by [policy]. A policy name must begin with a
letter and be no longer than 32 characters. Valid characters are 0-9, A-Z, a-z, _, $,
^, and -. The Security Policy database supports a maximum of 128 user-defined
policies. You must enter the Ipsec Save command afterwards to save your
changes.
Table 14-7 describes the policy parameters:
Table 14-7. Policy Configuration Parameters
Parameter Description
Description Description of the policy
SourceAddress IP address (version 4 or 6) or DNS host name of the host,
switch, or gateway from which data originates.
SourcePort Source port number (1–65535)
DestinationAddress IP address (version 4 or 6) or DNS host name of the host,
switch, or gateway receiving data. If you specified an IP address
for the SourceAddress, the DestinationAddress must use the
same IP version format.
DestinationPort Destination port number (1–65535)