Qlogic SANbox 5800V Series, Interface Manual

Page: 249 / 422

14 – Command Reference
Command Listing
59263-02 A 14-69
A
switch
Resets the switch without a power-on self test. This is the default. This reset
disrupts traffic and does the following:
„
Activates the pending firmware.
„
Closes all management sessions.
„
Clears the event log. To save the event log before resetting, refer to the
“Set Log” command on page 14-101 .
To reset the switch with a power-on self test, refer to the “Hardreset” command on
page 14-37 . To reset the switch without disrupting traffic, refer to the “Hotreset”
command on page 14-40 .
system
Resets the system configuration settings to the factory default values as
described in
Table 14-17 .
zoning
Clears the zoning database and deactivates the active zone set. The zoning
configuration parameters (MergeAutoSave, DefaultZone, DiscardInactive) remain
unchanged. Refer to
Table 14-13 for information about the zoning configuration
parameters.
NOTE:
The following files are deleted from the switch during a switch reset:
„
Firmware image files that have not been unpacked
„
Configuration backup files
„
Support files
NOTE:
„
Because this keyword changes network parameters, the
workstation could lose communication with the switch.
„
This keyword does not affect installed license keys.