Qlogic SANbox 5800V Series, Interface Manual

Page: 195 / 422

14 – Command Reference
Command Listing
59263-02 A 14-15
A
save [config_name]
Saves changes made during a configuration edit session in the configuration
given by [config_name]. If you omit [config_name], the value for [config_name]
you chose for the most recent Config Edit command is used. [config_name] can
be up to 31 characters excluding #, semicolon (;), and comma (,). The switch
supports up to 10 configurations including the default configuration.
Notes
Changes you make to an active or inactive configuration can be saved, but will not
take effect until you activate that configuration.
Examples
The following shows an example of how to open and close a Config Edit session:
SANbox #> admin start
SANbox (admin) #> config edit
The config named default is being edited.
.
.
SANbox (admin-config) #> config cancel
Configuration mode will be canceled. Please confirm (y/n): [n] y
SANbox (admin) #> admin end
NOTE:
„
If the restore process changes the IP address, use the
Set Setup System command to return the IP configuration to the values
you want. If the IP address is unknown, you must place the switch in
maintenance mode and reset the network configuration to restore the
default IP address 10.0.0.1. Refer to the installation guide for information
about using maintenance mode.
„
Configuration archive files created with the Enterprise Fabric Suite 2007
Archive function are not compatible with the Config Restore command.
„
The configdata backup file does not include the security group primary or
secondary secrets, and therefore are not restored. You must edit the
security database and reconfigure the secrets. If they are not, the switch
will isolate from the fabric.