Qlogic SANbox 5800V Series, Interface Manual

Page: 176 / 422

13 – Simple Network Management Protocol Configuration
Modifying the SNMP Configuration
13-4 59263-02 A
S
Modifying the SNMP Configuration
Enter the Set Setup SNMP command in an Admin session to configure SNMP on
the switch. There are two groups of configuration parameters. One group is
common to all traps. The second group is trap specific. You can configure both
groups of parameters for all SNMP traps, or you can configure the common and
trap-specific parameters separately. Refer to
Table 14-30 for descriptions of the
common and trap-specific SNMP parameters.
The following example configures the common SNMP trap configuration
parameters:
SANbox (admin) #> set setup snmp common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
SnmpEnabled True
Contact <sysContact undefined>
Location <sysLocation undefined>
ReadCommunity public
WriteCommunity private
AuthFailureTrap False
ProxyEnabled True
SNMPv3Enabled False
New Value (press ENTER to not specify value, 'q' to quit):
SnmpEnabled (True / False) :
Contact (string, max=64 chars) :
Location (string, max=64 chars) :
ReadCommunity (string, max=32 chars) :
WriteCommunity (string, max=32 chars) :
AuthFailureTrap (True / False) :
ProxyEnabled (True / False) :
SNMPv3Enabled (True / False) :
Do you want to save and activate this snmp setup? (y/n): [n]