Qlogic SANbox 3810, Interface Manual

Page: 86 / 396

Port Configuration
Port Binding
5-8 59270-00 A
S
You can configure all ports based a specified source port using the
Set Config Ports command. The following example configures ports 0–7 based on
port 3.
SANbox #> admin start
SANbox (admin) config edit
SANbox (admin) #> set config ports 3
.
.
.
SANbox (admin-config)#> config save
SANbox (admin)#> config activate
SANbox (admin)#> admin end
The following example temporarily changes the port 1 administrative state to
Down:
SANbox #> admin start
SANbox (admin) #> set port 1 state down
Port Binding
Port binding establishes up to 32 devices that are permitted to log in to a particular
switch port. Devices that are not among the 32 are refused access to the port.
Enter the
Show Config Security Portbinding command to display the port binding
configuration for all ports as shown in the following example.
SANbox #> show config security portbinding
Configuration Name: default
-------------------
Port Binding Status WWN
---- -------------- ---
0 True 10:20:30:40:50:60:70:80
1 True 10:20:30:40:50:60:70:80
2 False No port binding entries found.
3 True 10:20:30:40:50:60:70:80
4 True 10:20:30:40:50:60:70:80
5 False No port binding entries found.
6 True 10:20:30:40:50:60:70:81
7 False No port binding entries found.