Qlogic SANbox 3810, Interface Manual

Page: 286 / 396

Command Reference
Set Setup System
13-118 59270-00 A
S
ipv4
Prompts you in a line-by-line fashion to change the switch IPv4 Ethernet
configuration parameters described in
Table 13-32 . To configure all system
parameters, omit the keyword. For each parameter, enter a new value or press
the Enter key to accept the current value.
ipv6
Prompts you in a line-by-line fashion to change the switch IP version 6 Ethernet
configuration parameters described in
Table 13-33 . To configure all system
parameters, omit the keyword. For each parameter, enter a new value or press
the Enter key to accept the current value.
NOTE:
Changing the IP address will terminate all Ethernet management sessions.
Table 13-32. IP Version 4 Ethernet Configuration Parameters
Entry Description
EthIPv4NetworkEnable Enables (True) or disables (False) the IP version 4 inter-
face. The default is True.
EthIPv4NetworkDiscovery Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
4 - RARP. The default is 1 - Static.
EthIPv4NetworkAddress Ethernet IP address. The default is 10.0.0.1.
EthIPv4NetworkMask Ethernet IP subnet mask address. The default is
255.0.0.0.
EthIPv4GatewayAddress Ethernet address gateway. The default is 10.0.0.254
NOTE:
Changing the IP address will terminate all Ethernet management sessions.
Table 13-33. IP Version 6 Ethernet Configuration Parameters
Entry Description
EthIPv6NetworkEnable Enables (True) or disables (False) the IP version 6 inter-
face. The default is True.
EthIPv6Discovery Ethernet boot method: 1 – Static, 2 – DHCPv6, 3 – Ndp.
The default is 1 - Static.
EthIPv6NetworkAddress Ethernet IP address