Qlogic SANbox 3810, Interface Manual

Page: 259 / 396

Command Reference
Set Config Threshold
59270-00 A 13-91
A
Set Config Threshold
Sets the port alarm threshold parameters by which the switch monitors port
performance and generates alarms. The changes you make with this command
are not retained when you reset or power cycle the switch unless you save them
using the
Config Save command.
Authority
Admin session and a Config Edit session
Syntax
set config threshold
Initiates a configuration session by which to generate and log alarms for selected
events. The system displays each event, its triggers, and a sampling window one
line at a time and prompts you for a value. For each parameter, enter a new value
or press the Enter key to accept the current value shown in brackets.
Table 13-23
describes the port alarm threshold parameters.
Table 13-23. Port Alarm Threshold Parameters
Parameter Description
Threshold Monitoring Enabled Master enable/disable parameter for all events.
Enables (True) or disables (False) the generation
of all enabled event alarms. The default is False.
CRCErrorsMonitoringEnabled
DecodeErrorsMonitoringEnabled
ISLMonitoringEnabled
LoginMonitoringEnabled
LogoutMonitoringEnabled
LOSMonitoringEnabled
The event type enable/disable parameter. Enables
(True) or disables (False) the generation of alarms
for each of the following events:
„
CRC errors
„
Decode errors
„
ISL connection count
„
Device login errors
„
Device logout errors
„
Loss-of-signal errors
Rising Trigger The event count above which a rising trigger alarm
is logged. The switch will not generate another ris-
ing trigger alarm for that event until the count
descends below the falling trigger and again
exceeds the rising trigger.
Falling Trigger The event count below which a falling trigger alarm
is logged. The switch will not generate another fall-
ing trigger alarm for that event until the count
exceeds the rising trigger and descends again
below the falling trigger.
Sample Window The time in seconds in which to count events.