Qlogic SANbox 3810, Interface Manual

Page: 297 / 396

Command Reference
Show Alarm
59270-00 A 13-129
A
Show Alarm
Displays the alarm log and session output stream display setting.
Authority
None
Syntax
show alarm
settings
Keywords
settings
Displays the status of the parameter that controls the display of alarms in the
session output stream. This parameter is set using the
Set Alarm command.
Notes
The alarm log is cleared when the switch is reset or power cycled.
Examples
The following is an example of the Show Alarm command:
SANbox #> show alarm
[1][Thu Jan 29 15:20:49.471 CST 2009][A][1005.0034][System resource error -
contact technical support]
[2][Fri Jan 30 14:04:19.566 CST 2009][A][1005.000D][Port: 0][Configuration error,
insufficient credit in pool. Extended credit not granted for port]
[3][Fri Jan 30 14:04:19.566 CST 2009][A][1005.000D][Port: 0][Warning: The
ungranted request can result in inconsistent credit distribution upon reset]
[4][Fri Jan 30 14:04:19.567 CST 2009][A][1005.000D][Port: 7][Configuration error,
insufficient credit in pool. Extended credit not granted for port]
[5][Fri Jan 30 14:04:19.567 CST 2009][A][1005.000D][Port: 7][Warning: The
ungranted request can result in inconsistent credit distribution upon reset]
[6][Wed Feb 11 13:02:05.846 CST 2009][A][1003.0032][ZoneSet Activation failed,
zoneset julieo failed validity checks (empty or contains empty zone/alias)]
The following is an example of the Show Alarm Settings command:
SANbox #> show alarm settings
Current settings for alarm
--------------------------
display ON