8
Figure 1.5. State monitoring mode navigation
Here: Monitoring parameter only can be used to check, cannot be modified or set.
Parameter verifying mode
When f618=1, the MODE key can switch to parameter calibration mode.
In the calibration mode, you can see all the factory default setting different parameters,
and the parameter setting method of these parameters set the same pattern, as shown
in Figure 1.4.
Note: Without any changing of the parameters, if press ENT button, it will not display “-
uf-”.
State monitoring
mode
u 000
u 4 --
e - 01
u400
(
History fault monitoring
)
u 1 --
u 4 09
0.0
MODE
u 001
u 023
(
Current state monitoring
)
V 100
ESC
ENT
ENT
ESC
ESC
ENT
(
Current state monitoring
)
(
History fault monitoring
)
