Qingqi QM110GY, Owner'S Manual

Page: 38 / 48

-37-
measured at clutch lever should be 4
mm. If the clutch wire clearance is
found incorrect, carry out adjustment
as follows.
Loosen nut (2) and rotate the
lever tensioning ring (3) clockwise
to the stop. Loosen the wire rope
adjusting ring lock nut (6), and
rotate the wire tensioning ring (5)
back and forth, until the lever
clearance is about 4 mm. Lever
tensioning ring (3) can be used for
fine tuning. After the adjustment is
completed, tighten locking nut (2)
and (6), and cover them with
rubber sleeve (4).
Adjustment of drive chain
Adjusting bolt Locking nut
Mark Rear wheel shaft nut
To adjust:
1 Park the motorcycle with central
stand.
2
Loosen rear wheel shaft nut.
3 Loosen the locking nut.
4 Rotate the adjusting bolt left and
right to adjust the chain.
Note
When a new chain is installed,
it is necessary to check both chain
wheels. Replace if necessary.
The drive chain tension should
be adjusted every 1000 km, to keep
a movable distance of 20 - 30 mm in
the midpoint of the two chain
wheels.