Qingqi QM110GY, Owner'S Manual

Page: 37 / 48

-36-
important to engine service life.
Carburetor
A stable carburetor is the
basis of guaranteeing the engine
performance. Before leaving the
factory, carburetor has been adjusted
to the best condition. Any
unnecessary adjustment should be
avoided. Please note that, there are
two adjustment items for carburetor,
i.e., accelerator wire clearance and
idle speed. Carry out adjustment
after the first 1000 km and every
3000 km thereafter, as follows.
Adjustment of carburetor idle
speed RPM
1 Start the engine and allow it to
fully warmed-up without load.
2 Close the accelerator. Rotate the
idle adjusting screw to keep the
engine running at 1500±100
rpm.
Precaution
Idle speed adjustment should
be carried out while the engine is
fully warmed up.
Adjustment of accelerator wire
Locking nut Adjuster
1 Loosen the locking nut.
2 Rotate the adjuster to make the
wire clearance between 0.5 - 1.0
mm.
3 After clearance adjustment,
tighten the locking nut once
again.
Precaution
After accelerator wire
adjustment, check the operation of
accelerator grip. Engine idle speed
should not increase due to the
adjustment, and the grip should
return to the closed position
automatically.
Adjustment of clutch
Clutch adjustment is made
through adjusting the tension of wire
rope for clutch lever. Before feeling
the gear disengagement by pressing
the clutch lever, the wire clearance