Qingqi QM110GY, Owner'S Manual

Page: 30 / 48

-29-
3 Remove drain plug from
strainer cover on the engine bottom
to drain oil.
Note
Be careful not to remove the
neutral gear positioning screwed
plug to avoid dropping of neutral
gear cam pin and spring, resulting in
difficult gear shifting.
4 Remove three screws from filter
element cover.
Cap nut Filter element cover
5 Remove filter element cover, pull
out oil filter element and replace it
with a new one.
Precaution
Insert the opening part of oil
filter element in the engine and
check if the element is installed
firmly.
6
Before reinstalling the filter
element cover, check for any
mistake in installation of the spring
and gasket of oil filter element.
Precaution
The gasket should be replaced
with a new one each time when the
element is replaced.
7 Install the filter element cover and
screw on the nut. Do not fasten the
nut excessively tight.
8
Tighten the oil drain ring and fill
fresh engine oil about 950 ml into
the oil filler, before gently tightening
the top cover.
Note
If only oil is changed without
replacing the element, the volume of
fresh oil is 850 ml.
9
Start the engine and allow it
running idle speed for several
seconds.
Precaution
Carefully check for any oil
leakage around the filter element
cover.
10
Shutdown the engine and wait
for a minute before checking the oil
level from engine oil window. The
oil should be kept on "F" (full) line.
If the oil level is below "F" line,
replenish until it reaches the "F".
Precaution
Please use the engine oil