Qingqi QM110GY, Owner'S Manual

Page: 11 / 48

-10-
signal light OFF.
Horn button (4) Press "
" button
and the horn will sound.
Clutch lever (5) To start the engine
or make a gear shifting, press the
lever to release the drive system and
cut off the clutch.
Right handlebar control system
Front brake lever (1)
To apply front wheel brake,
slowly press the brake lever on the
right handlebar. As the motorcycle
adopts hydraulic braking
do not
press it abruptly or forcefully.
When the brake lever is pressed,
the brake light will be lit
automatically.
Engine shutdown switch (2)
The switch is a rocker switch,
located on the tip of right handlebar
control panel, with the rockshaft at
the center of the rocker. When it is
pressed in " " start position, the
switch is turned and the engine can
be started. It is an emergency switch.
If the switch is pressed in " "
position, the starting circuit is
completely cut off and the starter
motor cannot be started. Do not put
the switch in this position during
riding.
Accelerator grip (3)
Accelerator grip is used to
control the engine speed. To
accelerate, turn the grip towards
yourself. To decelerate, turn the grip
away from yourself.
Electric start button (4)
Press" " button to turn on
the start motor circuit. During
starting, put in neutral gear position
to cut off transmission and guarantee
safety.
Warning
The starter motor should be
operated not more than 5 seconds.
Heavy discharge may cause overheat
to circuit and starter motor. If
starting is failed after several
attempts, stop to check the fuel
supply system and starting circuit
(refer to "Troubleshooting").
Fuel tank cap