-20-
result in starting difficulty. In this case, do not rotate the accelerator grip, but
repeat starting.
2
Starting with the kickback start lever
When the battery is over discharged, the engine can be started by using
the kickback start lever.
Turn the ignition switch to ON position.
Forcefully kick the kickback start lever.
Cold engine
Put the carburetor enrichment handle (plunger carburetor) or lever
(vacuum carburetor) to the highest position (plunger) or pull it fully out
(vacuum carburetor), keep the accelerator closed, and press the electric start
button; After the engine is started, press the handle half way down (plunger)
or push the lever half way in (vacuum) and wait for the engine is adequately
warmed-up, before putting the handle or lever to the original position. The
colder it is, the longer warm-up time the engine takes. Otherwise, the
acceleration may be poor.
Warm engine
Rotate accelerator grip for 1/8 - 1/4 turns, and press electric start button
to start the engine. When the engine is warm, it is not necessary to use
carburetor enrichment system.
Warning
Never start the engine in a room with poor or no ventilation because
carbon monoxide gas is poisonous. Never leave the motorcycle unattended
with a running engine.
Precaution
Do not allow the engine run for a long time without riding, or the
engine may get overheat causing damage to internal parts or chrome plating of
exhaust system.
Start riding the motorcycle
Precaution
Start the engine with the transmission in neutral position, the clutch
engaged and driver riding in normal riding position.
Firmly press the clutch lever, wait a little moment, press down the gear
lever to engage the first gear, rotate the accelerator grip slowly to you and
smoothly and slowly release the clutch lever. When the clutch is engaged, the
motorcycle will move forward.
Summary of Contents for QM110GY
Page 43: ...42...
Page 47: ...46 Chapter 12 Circuit Diagram...
