Qingqi QM110GY, Owner'S Manual

Page: 36 / 48

-35-
increased.
Clean the foam type filter as
follows:
A
B
1 Fill a pan of proper size with
incombustible cleaning solution.
Immerge the filter element in
the cleaning solution and wash
it.
2 Press the filter element with
both palms to squeeze out
cleaning solution. Never twist
the filter element to avoid
damaging.
3 Soak the filter element in engine
oil tank and squeeze oil out,
keeping it slightly wet.
Precaution
Before and during cleaning,
attention should be paid to check the
filter element for any crack. Replace
it if any crack is found.
4
Reinstall the filter in reverse
order. Make sure the filter
element is firmly fixed in
correct position and reliably
sealed.
Cleaning of paper filter element
Cleaning method is as follows:
1 Remove the left side guard board.
2
Remove the tensioning band
screw of air filter connector. Pull out
the intake pipe and separate it from
the filter.
3
Take out the filter element
4 Pat the filter element while
rotating it, to remove dust, and blow
off remaining dust by using
compressed air.
5 The filter element is made of
paper and cannot be cleaned by
using any oil-based agent.
Precaution
Before and during cleaning, pay
attention to check the filter element
for any contamination, crack or
damage. Replace it with a new one
when necessary.
Reinstall the filter in reverse
order. Make sure the filter element is
firmly fixed in correct position and
reliably sealed.
Precaution
Never start the engine without
the air filter installed. The air filter
element must be cleaned or replaced
more frequently if the motorcycle is
used in dusty conditions. Never start
the engine without the filter element
installed, or the engine wearing may
be increased. Be sure to the air filter
element is in good working
conditions, because this part is very