Proware SN-3163S3H-QX, User Manual

Page: 33 / 237

SAS / SATA II NAS System
User Manual 33
Chapter 4 RAID Configuration Utility Options
Configuration Methods
There are f o u r methods of configuring the RAID controller:
a. VT100 terminal connected through the serial Monitor port
b. Front panel touch-control buttons
c. Web browser-based remote RAID management via the R-Link Ethernet port
d. Telnet connection via the R-Link Ethernet port
NOTE: The RAID subsystem allows you to access using only one
method at a time. You cannot use more than one method at the
same time.
4.1 Configuration through Terminal
Configuring through a terminal will allow you to use the same configuration options
and functions that are available from the LCD panel and via Telnet. To start-up:
1. Connect the Monitor port located at the rear of the system to another PC or a VT100
compatible terminal operating in an equivalent terminal emulation mode using serial
cable.
NOTE: You may connect a terminal while the system’s power is on.
2.
Power-on the terminal.
3. Run the VT100 program or an equivalent terminal program.