Proware SN-3163S3H-QX, User Manual

Page: 228 / 237

SAS / SATA II NAS System
228 User Manual
12. Wait until the
status of the local
and peer server
are in be standby-
standby mode
respectively. The
statuses of the
private net must
also be "Enabled
and Healthy". If
this is not the
output, check and
repeat previous
steps.
13. Go to "Resource Group Manager" then press "Add Resource Group".
The Resource Group Manager of proNAS HA is used to manage resource
groups. Users need to configure resource groups only on one of the servers,
usually the Active server. proNAS HA will automatically synchronize the status
of resource groups between both servers. Note that users are prohibited to
create or remove resource groups unless proNAS HA are running on both
servers and at least one of the private net is functioning.
Buttons:
Add
Resource
Group button Add new resource group member. User can specify the
name of the resource group. This name must be unique
for the resource groups within the cluster
Switch All
Resource
Groups from
Peer This is to manually takeover the all resource groups from
the peer server. Users can manually takeover resource
groups from the peer server to perform maintenance or
troubleshooting on the active server. This button will be
displayed only if resource groups are bring in.
Switch All
Resource
Groups to
Peer This is to manually failover the all resource groups to the
peer server. Users can manually failover resource groups
to the peer server to perform maintenance or
troubleshooting on the active server. This button will be
displayed only if resource groups are bring in.