![background image](http://html1.mh-extra.com/html/pronto/magicard-3649-0001/magicard-3649-0001_maintenance-manual_1617575087.webp)
Ultra Electronics Ltd
Pronto Maintenance Manual
- 87 -
22:04
Not applicable to the PRONTO.
22:05
This error is raised when performing the Sensor test routine on a Pronto Engine upon completion of
the test.
22:06
This error is raised when performing the Sensor test routine on a Pronto Engine if the Cam Sensor
does not toggle.
23 - WRONG PSU
Please switch Printer off and check the Power Supply.
23:00
23:00
This error is raised after initialising the Cam at boot up if the time taken to rotate the Cam by half a
turn was longer than 2.5 seconds, indicating a low level output from the PSU.
24 - GENERAL ERROR
Please contact Technical Support, quoting Error Code.
24:00
24:00
This error is raised while processing a downloaded Firmware binary file if the file length is greater
than 1170432 bytes (1143 kB).
24:01
This error is raised while attempting to write a downloaded Firmware binary into ash memory if the
embedded ID string in the downloaded file is incorrect. This would happen if, for example, a Pronto
binary was somehow sent to an Enduro Printer.
24:02
This error is raised while trying to erase an ash memory sector if there is a timeout waiting for the
operation to complete.
24:03
This error is raised after printing a Card if the postprint Dye-Film RFID Tag check (which involves
incrementing the Tag's print counter) fails.
24:04
This error is raised while trying to feed a Card from the Hopper to the print Engine if the Printer sees
the mid Sensor block before the rear one does. This could possibly indicate that the rear Sensor has
dropped out of position, but could also mean that the mid Sensor is faulty.
24:05
This error is raised while trying to feed a Card from the Hopper to the print Engine if the Printer sees
the front Sensor block before the rear and mid ones do. This could possibly indicate that both the
rear and mid Sensors have dropped out of position, but could also mean that the front Sensor is
faulty.
24:06
This error is raised while trying to feed a Card from the Hopper to the print Engine if the Printer sees
the front Sensor block before the mid one does. This could possibly indicate that the mid Sensor has
dropped out of position, or that the front Sensor is faulty.
24:07
This error is raised while trying to hand feed a Card into the print Engine if the Printer sees the mid
Sensor block before the front one does. This could possibly indicate that the front Sensor has
dropped out of position, or that the mid Sensor is faulty.
24:08
This error is raised while trying to hand feed a Card into the print Engine if the Printer sees the rear
Sensor block before the front and mid ones do. This could possibly indicate that both the front and
mid Sensors have dropped out of position, or that the rear Sensor is faulty.