![background image](http://html1.mh-extra.com/html/pronto/magicard-3649-0001/magicard-3649-0001_maintenance-manual_1617575083.webp)
Ultra Electronics Ltd
Pronto Maintenance Manual
- 83 -
08:03
This error is raised while running a Tacho Sensor test (via the "TAC" quick command) if no Tacho
Sensor transitions are seen for at least 4 seconds.
08:04
This error is raised while printing a colour panel if no Tacho or Dye Sensor transitions are seen for at
least 150 printed lines (this equates to roughly 150 ms).
08:05
This error is raised while printing a black panel if no Tacho or Dye Sensor transitions are seen for at
least 150 printed lines (this equates to roughly 75 ms).
08:06
This error is raised while printing an overcoat panel if no Tacho or Dye Sensor transitions are seen for
at least 150 printed lines (this equates to roughly 150 ms).
08:07
This error is raised during Dye-Film initialisation if the print counter on the Dye-Film's RFID tag has
reached its limit.
08:08
This error is raised while carrying out the vaLidation checks that are done just prior to printing each
Card if the print counter on the Dye-Film RFID tag has reached its limit. Note that by this point the
Printer has already determined that the fitted Film is in principle capable of being used for the
downloaded print job (for example, it has the required colours).
08:09
This error is raised while trying to advance the Film to the start of the next panel if tacho transitions
are seen, but no Dye Sensor transitions are seen for at least 5 seconds.
08:10
This error is raised while trying to advance the Film to the start of the next panel if Dye Sensor
transitions are seen, but no tachos are seen for at least 5 seconds.
08:11
This error is raised while trying to advance the Film to the start of the next panel if tacho and Dye
Sensor transitions are seen, but the Dye panel Sensor change does not stabilise within 5 seconds.
This could be due to glitches, or an uncalibrated Dye LED (in which case the "FCL" command should
fix it).
08:12
This error is raised just prior to commencing printing if the black end-of-Film marker tape has been
detected.
09 - UNSUPPORTED DYE-FILM
Please load different Film to continue.
09:00
09:00
This error is raised while initialising the Dye-Film if the fitted Film has an unsupported configuration of
Dye panels. The currently supported configurations are: colour, resin and overcoat for full-colour
prints. Note that this error means that the Dye-Film's RFID tag was successfully vaLidated.
10 - WRONG DYE-FILM TYPE
Please load different Film to continue, or press Cancel to clear the print job.
10:00
10:00
This error is raised while advancing the Dye-Film to a specific position within a specific panel (for
example, moving the Film into a position where it can be used for printing) if the panel requested is
not present in the loaded Film type. For example, if a colour panel was requested when KO Film was
loaded.
10:01
This error is raised while determining the print event sequence for the current print job using LC1
type Film (in other words, Film having a YMCKO configuration) if the image cannot be printed using
the loaded Film.