![background image](http://html1.mh-extra.com/html/pronto/magicard-3649-0001/magicard-3649-0001_maintenance-manual_1617575082.webp)
Ultra Electronics Ltd
Pronto Maintenance Manual
- 82 -
06:18
This error is raised while trying to position the Card so that its rear edge just covers the rear Sensor
(ready for printing) if we fail to see the rear Sensor block within 3 seconds.
06:19
This error is raised while trying to position the Card so that its rear edge just covers the rear Sensor
(ready for printing) if we fail to see the rear Sensor unblock within 3 seconds. By this point the rear
Sensor has already been blocked by the Card moving backwards, and the Printer is moving the Card
forwards again until the Sensor just unblocks.
06:20
This error is raised in Pronto print Engines during the forward motion part of the soak test routine if
the Card cannot be seen to arrive at the front Sensor within 6 seconds.
06:21
This error is raised in Pronto print Engines during the backward-motion part of the soak test routine if
the Card cannot be seen to arrive at the rear Sensor within 6 seconds.
06:22
This error is raised while feeding a Card from the Hopper into the standby position (covering the mid
Sensor) if we fail to see the front Sensor block within 6 seconds. By this point the Card has already
been successfully extracted from the Hopper, and the Printer is trying to move it all the way to the
front Sensor before returning it to the standby position.
06:24
Not applicable to the PRONTO.
06:25
Not applicable to the PRONTO.
06:26
This error is raised in Pronto Engines while rewinding the Card to the standby position (after mag
encoding) if the mid Sensor does not block within 5 seconds.
06:27
Not applicable to the PRONTO.
07 - NO DYE-FILM DETECTED
Please load valid Film to continue.
07:00
07:00
This error is raised while initialising the Dye-Film if the Printer cannot vaLidate the information in the
header of the Dye-Film's RFID tag. Note that this tag vaLidation process is not performed when no
tag is present|the Printer just assumes that a roll lacking a tag is monochrome. Thus, this error is
only raised when the tag is detected but invaLid.
08 - OUT OF DYE-FILM
Please load a new roll of Film to continue.
08:00
08:00
This error is raised while trying to advance the Film to the start of the next panel if no tacho or Dye
Sensor transitions are seen for at least 5 seconds.
08:01
This error is raised while trying to advance the Film by a certain fixed offset (for example, to line up
the start of the panel with the printing position) if no tacho or Dye Sensor transitions are seen for at
least 5 seconds.
08:02
This error is raised while collecting data for the calibration of the Dye LEDs if no tacho transitions are
seen for at least 5 seconds while trying to move the Film between measurements.