![background image](http://html1.mh-extra.com/html/pronto/magicard-3649-0001/magicard-3649-0001_maintenance-manual_1617575079.webp)
Ultra Electronics Ltd
Pronto Maintenance Manual
- 79 -
01:12
This error is raised if, at the end of a print job, we detect that the Lid is open. This will usually mean
that the print job aborted early due to the Lid being opened, but could also mean (in extremely rare
circumstances) that the Lid was opened just after the point when the job actually finished
successfully.
01:13
This error is raised while trying to hand-feed a Card on Pronto Engines, if the Lid is opened during the
hand feed process. This error only occurs if the Lid is opened before a Card has been seen at the
front Sensor, during the phase where the motor is still running.
01:14
This error is raised while trying to hand-feed a Card on Pronto Engines, if the Lid is opened during the
hand- feed process. This error only occurs if the Lid is opened before a Card is seen at the front
Sensor, during the phase where the motor is `resting' (waiting for the front Sensor to block before
starting again).
01:15
This error is raised while trying to hand-feed a Card on Pronto Engines, if the Lid is opened during the
hand feed process. This error only occurs if the Lid is opened after the front Sensor is blocked, but
before the mid Sensor is blocked.
02 - OUT OF CARDS
Applicable to Hopper fed Cards.
02:00
02:00
Not applicable to the PRONTO.
03 - HAND FEED ERROR
Please select Retry to try again.
03:00
03:01
This error is raised in Pronto Engines during hand-feeding if the Printer could not feed a Card into the
Engine within 3 attempts.
04 - CARD JAM 1
Please clear Printer mechanism.
04:00
04:00
This error is raised if the front Sensor becomes blocked when trying to hand-feed a Card, but does
not unblock within 5 seconds.
04:01
This error is raised while trying to get a Card out of the Smart Encoding unit if the front Sensor
remains clear for more than 5 seconds.
04:02
This error is raised while trying to get a Card out of the Smart Encoding unit if the front Sensor stays
blocked for more than 5 seconds.
04:03
Not applicable to the PRONTO.
04:04
Not applicable to the PRONTO.
04:05
This error is raised while trying to rewind the Card to the standby position (i.e. Over the mid Sensor)
if the front Sensor stays clear for more than 2 seconds. This function is called to reposition the Card
after performing mag verification in the forwards direction.