
SECTION 4
Pronar T743
4.13
•
In the event of trailer malfunction, pull over on the hard shoulder avoiding any
risk to other road users and position reflective warning triangle according to
traffic regulations.
•
While driving on public roads the trailer must be fitted with a certified or
authorised reflective warning triangle. When driving, comply with all road traffic
regulations, indicate an intention to turn using indicator lamps, keep all road
lights and indicator lights clean at all times and ensure they are in good
condition. Any damaged or lost lamps or indicator lights must be immediately
repaired or replaced.
•
Avoid ruts, depressions, ditches or driving on roadside slopes. Driving across
such obstacles could cause the trailer or the tractor to suddenly tilt. This is of
special importance because loaded trailer's centre of gravity is higher, which
reduces safety. Driving near ditches or canals is dangerous as there is a risk of
the wheels sliding down the slope or the slope collapsing.
•
When driving, avoid sharp turns especially on slopes.
•
Please note that the braking distance of tractor and trailer combination is
substantially increased at higher speeds and loads carried in the trailer.
•
Speed must be sufficiently reduced before making a turn or driving on an
uneven road or a slope.
•
During reversing one should use the assistance of another person, who gives
directions standing clear of the danger zone.
•
Before driving backwards, extend the blocking steering system hydraulic cylinders
using the tractor distributor lever.
4.8
UNLOADING
Unloading with the aid of vertical conveyor
Tractor and trailer must be placed to drive forwards on flat ground.
Immobilise tractor and trailer with parking brake.
Set gear ratio change lever (1) figure (4.5) to position (B) or (C).
Summary of Contents for T743
