PRONAR T743, Operator'S Manual

Page: 36 / 150

SECTION 2 Pronar T743
2.11
•
The trailer must not be supported using fragile elements (bricks or concrete
blocks).
•
Unauthorised adjustment of rear wheel alignment is strictly forbidden. Incorrect
alignment leads to accelerated tyre wear and hinders steering.
•
Do NOT change the settings of bolts placed on axle body limiting angle of axle
turning (turning block bolts are set in the factory). Change of bolt settings may
cause damage to braking system elements and damage to tyres.
•
After completing work associated with lubrication, remove excess oil or grease.
The trailer should be kept clean and tidy.
•
Exercise caution when climbing on top of the load box. Climbing on top of the
load box is possible through the fenced platform, ladders placed on the back wall,
while extension and folding steps attached inside the load box. Do not use
mudguards and wheels etc. for this purpose. Before entering load box prevent
trailer moving with parking brake and chocks.
•
Do not make independent repairs of control valve, brake cylinders and braking
force regulator. In the event of damage to these elements, repair should be
entrusted to authorised service point or replace elements with new parts.
•
Do NOT make repairs to drawbar eye (straightening, repairing or welding).
Damaged drawbar eye should be replaced.
•
After changing the hydraulic oil, the used oil should be properly disposed of.
2.1.7 LOADING AND UNLOADING
•
Loading and unloading work should be carried out by someone experienced in
this type of work.
•
The trailer is not intended for transporting people, animals or hazardous
materials, to which separate regulations apply.
•
Do NOT exceed the trailer's maximum carrying capacity. Exceeding the carrying
capacity may lead to damage to the machine, loss of stability while driving,
scattering of the load and danger while driving. The brake system is adjusted to
the gross weight, exceeding the weight limit causes drastic reduction of basic
braking effectiveness.