PROALL P Series, Service Manual, Page: 59 / 118

59
Figure 35. Typical worn stir tabs shown next to auger wear plates. The closest stir tab shown in this figure should have its wear plate replaced
because the tab itself is worn as much as it can be. The furthest stir tab in this figure may be worn more as the stir tab wear is over 1/8 inch from
the nut holding the stir tab wear plate to the stir tab.
Figure 36. A newly replaced auger wear plate shown next to older wear plates. The older wear plates in this figure are not yet in need of
replacement. New stir tab wear plates are shown on stir tabs that have worn down as far as possible without having to replace the stir tabs.
1. Remove the mix auger screw from the mix auger using the “6.1 BOTTOM IDLER SHAFT, SEAL AND BEARING
REMOVAL” and “6.4 TOP MOTOR, BEARING AND DRIVE SHAFT REMOVAL” procedures outlined above.
2. Cut the bolts off the wear plates and stir tabs using a cutting wheel or torch.
Note: Ensure the orientation of the replacement wear plates and stir tabs matches the replaced parts.
3. Install bolts (PN 1260358 & 233107) into the auger screw and replacement auger wear plates (PN AGWP002)
and stir tab wear plates (PN AGWP003) ensuring the bolt head is adjacent to the auger or stir tab wear plate.
Install the mix auger screw using the “6.2 BOTTOM IDLER SHAFT AND SEAL INSTALLATION”, “6.3 BOTTOM BEARING
INSTALLATION” and “6.5 TOP MOTOR, BEARING AND DRIVE SHAFT INSTALLATION