PROALL P Series, Service Manual, Page: 43 / 118

43
6. MIX AUGER SERVICE
Figure 1. Upper view and orientation of Mix Auger
Suggested grease: NLGI GC-LB standard grade 2 for wheel and chassis lubrication such as Petro Canada Precision XL EP2
Lithium or Delco ESI EP grade 2 NLGI Lithium or equivalent.
Suggested silicone: RTV silicone sealant such as Dow Corning DOWSIL 786 or equivalent.
Suggested anti-seize compound: Tool joint compound such as Jet-Lube Kopr-Kote or Loctite LB 8008 or equivalent.
6.1 BOTTOM IDLER SHAFT, SEAL AND BEARING REMOVAL
Note: when servicing idler shaft or idler shaft seal assembly only, the motor does not need to be removed but can remain
attached to the auger assembly. For removal of the motor, please see the “
6.4 TOP MOTOR, BEARING AND DRIVE SHAFT
REMOVAL ” section.
Note: To make removal easier, support the auger screw with a crane or other lifting device throughout the following
procedure.
1. Remove grease hoses (PN 189112)
Figure 2. Remove grease hoses
2. Remove bearing bolts
3. Loosen set screw on bearing.
4. Loosen bearing collar using a collar wrench or punch and mallet.
Top Bottom
Right
Left