PROALL P Series, Service Manual, Page: 74 / 118

74

If the pump is still not pumping or there is still air in the line,
try cracking the strainer bowl slightly to remove any
potential air locks. If fluid is running out and pump is
pumping tighten the bowl.
11.2 STRAINER CLEANING AND REPLACEMENT
IMPORTANT!
A dirty admix strainer will cause the Commander control system to speed up the admix pump when in auto
mode, which will eventually cause it to go into a fault if it can’t meet it’s admix flow target. Check the admix
strainer regularly for buildup.

To remove and inspect the admix inlet strainer unthread the
bowl and pull the strainer out of the housing.

Be careful not to lose the seal .

Clean the strainer as necessary ensuring all debris is
removed and outer mesh is clean.

Clean and dump any debris out of the bowl as well.

If the strainer is plugged beyond reasonable cleaning or it is
damaged, then replace it.
B
A
B
B
A
B