7.2.1 High Pass Filter
Use this control to set the High-Pass Filter frequency threshold for the selected Channel or Output Bus.
The filter’s threshold can be set from 24 Hz to 1 kHz. When the threshold is set to its lowest point, the fil-
ter is off. The high-pass filter’s slope is -12 dB/8va.
Power User Tip
:
A high-pass filter attenuates all frequencies below the set threshold. Usethe Fat Channel high-
pass filter to remove unwanted low frequencies from your source signal, rather than trying to EQ them out.
7.2.1 High Pass Filter
70
