Power Electronics GBC05CI, Manual

Page: 21 / 45

POWER ELECTRONICS ETHERNET GATEWAY
INSTALLATION AND CONNECTION
19
E
N
G
L
I
S
H
3.3. Connection for Equipments of Power
Electronics
The Ethernet Gateway supports the following Modbus slaves:

Variable Speed Drive of SD700 Series.

Variable Speed Drives of SD100, SD250 and SD450 Series.

Digital Soft Starter of V5 Series.

Medium Voltage Soft Starter of VS65 Series.

Medium Voltage Variable Speed Drive of XMV660 Series.
Note: To connect other slaves, contact with Power Electronics.
Finally, also the parameters related to the Modbus communication can
be configured:

Transmission Speed (Baud rate)

Exceeded Time (Time out)

Stop bit

Parity bit

Retries
3.3.1. Variable Speed Drives of SD100 Series
When using the Ethernet Gateway with SD100 drive, the last one
must have an optional board MODBUS-RTU SD100. All
requirements relative to the installation can be found in the user
manual provided with the optional board.
General specifications:

Transmission form: Bus method, Multi drop Link System.

Applicable drive: SD100.

Connectable drives: Maximum 31.

Transmission distance: Below 1.200m maximum (700m recommended).

Cable recommended: 0.75mm² (18AWG), Shielded twisted pair.

Installation: GN, N and P terminals

Power supply: Power supply insulated from the inverter power supply.