1-58
Usage Guide:
This function cannot change the command itself. LINE must be the whole command format, the command with the
abbreviation format must be analyzed successfully. For half-baked command, false command about writing and
command that abbreviation cannot be analyzed successfully, the configuration is failure. For changing the command
line with the parameter, it should fill in the parameter which is able to be selected discretionarily according to the
required format. However, level of the no command is able to be set optionally and it does not affect the result. When
using no command, LINE must be the configured command line. If the command line with the parameter, the
parameter must be matched with the configured command.
Example:
Change the level of
show ip route
command to level 5.
Switch(config)#privilege exec level 5 show ip route
Change the level of
peer A.B.C.D
command to level 6.
Switch(config)#privilege router-msdp level 6 peer 1.2.3.4
Restore the original level for
show ip route
command.
Switch(config)#no privilege exec level 5 show ip route
Restore the original level for
peer A.B.C.D
command.
Switch(config)#no privilege router-msdp level 6 peer 1.2.3.4
1.1.23 reload
Command:
Reload
Function:
Warm reset the switch.
Command mode:
Admin Mode.
Usage Guide:
The user can use this command to restart the switch without power off.