4-146
Usage Guide:
After executing this command, users will remotely login to a member switch and enter Admin Mode on the latter. Use
exit to quit the configuration interface of the member. Because of the use of internal private IP, telnet authentication
will be omitted on member switches. This command can only be executed on commander switches.
Example:
In the commander switch, enter the configuration interface of the member switch with member-id 1.
Switch#rcommand member 1
Chapter 4 Commands for Network Port
Configuration
4.1 Commands for Ethernet Port Configuration
4.1.1 bandwidth
Command:
bandwidth control <
bandwidth
> {transmit | receive | both}
no bandwidth control
Function:
Enable the bandwidth limit function on the port; the no command disables this function.
Parameter:
<bandwidth>
is the bandwidth limit, which is shown in kbps ranging between 1-1000000K; both refers to the
bandwidth limit when the port receives and sends data, receive refers to the bandwidth
limit
will only performed
when the switch
receives data from out side, while
transmit
refers to the function will be perform on sending only.
Command Mode:
Port Mode.
Default:
Bandwidth limit disabled by default.