Planet Networking & Communication SGS-6340-16XR, Command Manual, Page: 490 / 984

25-95
Function:
This command enables OSPF routing function one the interface with IP address matched with the network
address. The “
no network NETWORKADDRESS area < area-id >
“command removes the
configuration and
stop OSPF on corresponding interface.
Parameter:
NETWORKADDRESS = A.B.C.D/M | A.B.C.D X.Y.Z.W, Shown with the network address prefix or the mask.
Wildcast mask if shown in mask;
< area-id > is the ip address or area number shown in point divided domical system, if shown in decimal integer, it
ranges between 0~4294967295.
Default:
No default.
Command Mode:
OSPF protocol mode
Usage Guide:
When certain segment belongs to certain area, interface the segment belongs will be in this area, starting hello and
database interaction with the connected neighbor.
Example:
Switch#config terminal
Switch(config)#router ospf 100
Switch(config-router)#network 10.1.1.0/24 area 1
25.46 ospf abr-type
Command:
ospf abr-type {cisco|ibm|shortcut|standard}
no ospf abr-type
Function:
Use this command to configure a OSPF ABR type. The “
no ospf abr-type
” command restores the default value.
Parameter:
cisco , Realize through cisco ABR;