Pitney Bowes relay 3000, User Manual

Page: 79 / 120

OMR Scanning • 4
4-15 SV63138 Rev.A
Message Action
Bad OMR marks
Spacing
Two marks that are closer together than half the
expected distance are read. Check scan marks on
material.
No OMR marks • No marks on paper.
• Scan sensor is not centered over scan marks.
• Paper not loaded correctly.
Bad OMR Code
length
Code type on paper does not match the setup.
(Example: setup has OMR+ Sequence but paper
has OMR + Select Feed + Sequence. )
Bad OMR Code
format
A re-timing scan mark is missing. Check material.
(Example: mark 6 missing from a 10 mark code.)
Expected 1st
Sheet of set
The BOC mark (position 4) was present when it was
not expected. First page of the set was expected.
Not a new
Envelope
The BOC mark (position 4) was absent when it was
expected. Pages other than the first page of the set
were expected.
OMR: Parity Error The code doesn't have an even number of marks.
OMR: Sequence
Error
The sequence number is not sequential with the
previous page fed. Therefore, sheets are in the
wrong order or missing.
OMR: SF marks
Inconsistent
The Selective feed and Autobatch marks at
positions 7 to 9 are different from those on the
previous sheet of this set.
OMR: SF not in
Use
A selective feed mark is present at positions 7 to 8,
but the job setup does not include select feed.
OMR: Set too
Large
The set contains too many sheets from the main
feeder.
OMR: End of
Batch
Ready to Run
• Inserter has stopped for “End of Batch."
• Allows the operator to manually sort envelopes.
Mode Change
Recheck Feeders
Check sheet and insert feeder settings against the
job you are loading before exiting the setup mode.
OMR Error Messages