Pitney Bowes relay 3000, User Manual

Page: 13 / 120

1 ● System Overview
1-5 SV63138 Rev. A
5
Envelope Inverter - Transports the envelope into the stacker face up.
6
Drop Stacker or Output Device — located at the exit of the inserter,
this device collects finished mailpieces. This device can be latched
against the inserter when not in use. Alternatively, a range of power
stackers are available which offer greater capacity than the standard
drop stacker.
7
Fold Plate 1 and 2 — They create the desired fold in material fed
from the sheet feeder(s). The fold plates are automatically set from
the control panel.
8
Measuring Scale — The scale is located on the left side of the
inserter near the sheet feeders; used as an aid in measuring material
and envelopes.
9
Manual Advance Knob — The knob is located under a cover on
the front, left, lower corner of the inserter. Use it to turn the inserter
mechanisms by hand to help clear a material.
10
Power Switch — This switch turns the inserter on and off.
11
Side Guide Adjustment Knob — Use this knob to adjust the side
guides on the envelope feeder.
12
Envelope Feeder — Feeds envelopes into the inserting area where
they are filled with material requested from the other feeder(s).
13
Sheet Feeder 2 — Feeds material that requires folding. Its functions
are similar to those of sheet feeder 1, but the manual feed option is
NOT available from this feeder.
14
Sheet Feeder 1
— this feeder is intended for feeding material that
requires folding.
In addition, you can set sheet feeder 1 to
Manual Feed . In this mode,
you can run stapled sets of up to five sheets. The inserter waits for
you to feed each set by hand into sheet feeder 1 before folding and
inserting the set automatically.