Safety
v
SV63138 Rev. A
Safety Information
Follow these precautions whenever you use your inserting system:
• Read all instructions before you attempt to operate the system.
• Use this equipment only for its intended purpose.
• Place the system close to an easily accessible wall outlet.
• Place the system in an accessible location to allow for proper venting
of the equipment and to facilitate servicing.
• Use the AC power adapter included with this device. Third party
adapters may damage the device.
• Plug the AC adapter directly into a properly grounded wall outlet
located near the equipment and easily accessible. Failure to properly
ground the machine can result in severe personal injury and/or fire.
• The AC adapter/power cord is the primary means to disconnect this
device from the AC supply.
• DO NOT use a wall outlet controlled by a wall switch or one that is
shared with other equipment.
• DO NOT use an adapter plug on the line cord or wall outlet.
• DO NOT remove the ground pin from the line cord.
• DO NOT route the AC adapter power cord over sharp edges or trap it
between furniture. Make sure there is no strain on the power cord.
• If the unit becomes damaged, unplug it from the wall.
• Keep fingers, long hair, jewelry and loose clothing away from moving
parts at all times.
• Avoid touching moving parts or materials while the machine is in
use. Before clearing a jam, be sure machine mechanisms come to a
complete stop.
• Remove jammed material gently and carefully.
• DO NOT remove covers. Covers enclose hazardous parts that should
only be accessed by properly trained service personnel.
• DO NOT place lighted candles, cigarettes, cigars, etc., on the system.
• To prevent overheating, do not cover vent openings.
• Use only approved supplies.
• Improper storage and use of aerosol dusters or flammable aerosol
dusters can cause an explosive-like condition that could result in
personal injury and/or property damage.
• Never use aerosol dusters labeled flammable and always read
instructions and safety precautions on the duster container label.
Summary of Contents for relay 3000
