Pitney Bowes relay 3000, User Manual

Page: 39 / 120

Program a Job ● 2
2-13 SV63138 Rev. A
Run a Trial Piece
Run a trial piece to test the job settings.
1. Load material and tap the
Trial Piece button.
2. If you need to make changes to the settings based on the trial piece:
a. Tap the Setup button.
b. Log in with Supervisor access level
c. Tap the
icons to scroll to the setting you wish to modify.
d. Tap the icons to scroll to the desired option.
3. Tap the Setup button to accept the setting modification and return to
run mode. The inserter saves the job with the new settings.
4. Run another trial piece to test the modified settings.
NOTE: Any time you modify settings you must run a trial piece.
Incorrect Address Position - Adjust Fold Settings
When you run a trial piece, if the address is not in the correct position refer
to the Adjust Fold Settings table to help you fine tune your folds settings.
Adjust Fold Settings Table
Fold Type Address Too Low Address Too High
C - Letter Fold Decrease Fold A Increase Fold A and
increase Fold B by the
same amount.
Z - Accordion Fold Increase Fold A Decrease Fold A and
increase Fold B by the
same amount
Single Fold Increase Fold A Decrease Fold A
Double Fold Decrease Fold A Increase Fold A
It is recommended the fold is only adjusted by 0.20 inches (5mm) each time.