Pioneer DRM-300, Operating Instructions Manual

Page: 41 / 190

41
<DRC1285>
En
English
Power cable
Wiring monitor indicator
Termination indicator
(Busy indicator on DVD-R7783)
Changer interface cable
Wiring monitor indicator
Operation
5. Connect the changer interface cable.
¶
When the changer interface cable has been connected,
the wiring monitor indicator will flash at two-second
intervals.
NOTE:
Connect the changer interface cable to the connector
corresponding to the bay in which the drives have been
installed. (Note that labels are affixed to connectors indicating
the corresponding bay number.) Note that it is extremely
important to do this, as connecting the changer interface cable
to a neighboring bay will result in damage to discs and the
disc transport mechanism.
6. The changer will then read the drive’s SCSI ID and
compare the drive’s settings to those of existing drives.
¶
If all drives have been assigned different SCSI IDs, a
buzzer will sound once.
¶
If the same SCSI ID has been assigned to two or more
drives, a buzzer will sound three times.
4. Connect the power cable.
If it is difficult to work, the SCSI interface cables of other
drives should be disconnected before continuing.
¶
When the power cable has been connected, the wiring
monitor indicator on the rear of the drive (orange) will
light up.
¶
When terminator switch is set to ON, the termination
indicator (green) also lights (does not apply to DVD-
R7783).
NOTES:
¶
If installed drives are to be connected to different SCSI
buses, then the same SCSI ID assigned to each of the
drives may be all right.
¶
Even if none of the drives installed within a changer has
been assigned the same SCSI ID, it is necessary to check
that the same SCSI ID is not assigned to other devices
(e.g., hard disks) on the same SCSI bus.
7. Connect the SCSI interface cable.
If you have disconnected the SCSI interface cables of any
other drives in Step 4, be sure to remember to reconnect
those cables.
8. Enter system administrator mode and enter config
submode (see p. 28) to check that the changer
recognizes all the internal drives.
For example, three DVD-ROM drives and one DVD-R drive
have been added in the rear bays beginning from Bay #1
in sequence, the following messages will be displayed.
Press
»
key
≠
Press
»
key
≠
Press
»
key
≠
Press
»
key
≠